Composite wood products
Javad Torkaman; rouzbeh asadi khansari
Abstract
Fibre-gypsum board is a composite, in which fiber used as the reinforcement in the matrix of gypsum. The purpose of this article is to investigate the effect of different amounts of waste paper fibers on the strength, resistance and the fracture behavior of fiber-gypsum board. For this purpose, amounts ...
Read More
Fibre-gypsum board is a composite, in which fiber used as the reinforcement in the matrix of gypsum. The purpose of this article is to investigate the effect of different amounts of waste paper fibers on the strength, resistance and the fracture behavior of fiber-gypsum board. For this purpose, amounts of zero, 5, 10, 15, 20, 25 and 35 percent of waste paper fibers have been used. The results of measuring bending strength, internal bonding and moisture absorption during one month exposure to 100% relative humidity show that increasing the percentage of fibers up to 20% has increased the mechanical properties. In general, By using twenty percent fibers the bending strength increased fifty percent and the internal bonding became double and half in comparison to the control samples. The load-displacement curve shows that an increase of 5 to 15 percent of fibers does not change the fracture behavior of the fiber-gypsum board and they had brittle fracture same as control samples. While in more substitution values, the flexibility increases and the failure becomes ductile. Therefore, the best conditions in terms of strength, resistance, and flexibility have been obtained in 20% replacement of gypsum with waste paper fibers.
rouzbeh asadi khansari; Mohammadreza Dehghani Firouzabadi; Hossein Resalati
Abstract
The purpose of this research is to evaluate the effect of various paper coatings on initial contact angle and its evolution over time. We investigated nine coatings on two types of 75 g and 125 g printing papers. Seven coating compositions containing 80% clay, 20% ground calcium carbonate, dispersing ...
Read More
The purpose of this research is to evaluate the effect of various paper coatings on initial contact angle and its evolution over time. We investigated nine coatings on two types of 75 g and 125 g printing papers. Seven coating compositions containing 80% clay, 20% ground calcium carbonate, dispersing agent and various levels of polyvinyl acetate and lactic acid as binders were used. In the last two coatings, we used 100% precipitated calcium carbonate pigments, cationic starch, methacrylate, dispersant and two levels of cellulose nanofibers. In these suspensions, the amount of cellulose nanofibers in composition 8 is twice composition 9. After coating using rod method, the papers were dried then coated and control samples were calendered. We then performed contact angle measurements using water droplet and Kit No were performed. We noticed largest contact angle and smallest angle change over time for sample 6 containing 75% binder. Last two coatings contained cellulose nanofibers, which caused presence of hydroxyl group on the surface and lowered the contact angle. Composition eight was the most hydrophilic sample. Best barrier property Kit No and largest droplet volume after 20 seconds was accompanied with the increase of the binder percentage in the formulation. For the control sample and three treatments with highest binders, the contact angle over time remains relatively constant which is a sign of hydrophobicity. The correlation between contact angle and volume of the water droplet was determined to be 0.951 and 0.936 in the 75g and 125g papers relatively. We did not notice a significant difference in contact angle and Kit No between 75g and 125g samples.
