Document Type : Research Paper
Authors
1 M.Sc., graduate in pulp and Paper industry, Sari University of Agricultural Sciences and Natural Resources, Iran
2 Associate professor in wood and Paper industry, Sari University of Agricultural Sciences and Natural Resources, sari, Iran
3 Associate professor, Wood and Forests Products Division, Research Institute of Forests and Rangelands, Karaj, Iran
4 Assistant professor, North state university of Carolina, Postdoctoral student, USA
Abstract
The objective of this study was determination of the best method of bleaching including refining and bleaching (RB) or bleaching and then refining (BR) on chemical mechanical pulp (CMP) for the production of newsprint. Wood raw material consists of mixed wood forest species was chipped and air dried to calculate the moisture content. Wood composition percentages for CMP pulping was 40% poplar, 30% maple, 7.5% oak, 7.5% alder, 7.5% willow, and 7.5% Persimmon. In order to remove heavy metal ions of pulp, the chelating was carried out with DTPA. TCF Bleaching carried out by 3% H2O2 and 2.5% NaOH based on dry weight of pulp with initial brightness of 44.6% ISO. Pulp bleaching was done in two stages, before and after the refining by laboratory PFI mill beater. Finally, handsheets were made from the RB and BR treated pulps and the sheet properties were evaluated according to TAPPI test methods. The results showed that BR treatment increased tensile, burst, tear indices, brightness, scattering coefficient, and density, but reduced yellowing, opacity, and light absorption coefficient. The results confirmed the conventional method of CMP pulp treatment (BR) in MWPI.
Keywords
Main Subjects
)