A Study on the Possibility of Identification and Comparison of Metallic Ions and Chemical Components in Wood of Persuan maple and Caucasian maple tree by Atomic Absorption and GC-MS Methods

Vaysi, Ramin

doi:10.22092/ijwpr.2019.125647.1536

Document Type : Research Paper

Author

Ramin Vaysi

https://doi.org/10.22092/ijwpr.2019.125647.1536

Abstract

The aim of this study was accomplished on identification and comparison of chemical compounds in wood of maple tree. For this purpose, the samples were chosen randomly from persuan maple and Caucasian maple tree in Nowshahr's forest region. Then, flour and ash were provided from heartwood, sapwood of maple tree by TAPPI standards. For measured metallic ions, by atomic absorption method. The ions results showed that mn, co, fe, zn, and cu ions in Caucasian maple were more than persuan maple, but k ion was lower. Then extractives were separated from wood flour by acetone and extractives residue transferred to glass vial and was added BSTFA reactive agent to it. After samples prepared, samples were injected to the GC/MS device for it analysis. Identification of compounds was done by retention time of each compound, calculation of Quats index and Adams table. The result of GC-MS showed that there are 39 compounds in persuan maple, that benzaldehyde, bis (2-ethylhexyl)phthalate, gibberllin A3 and 1,2-benzenedicarboxylic acid were important components. 24 components identified in Acer leatum that di-limonene, bis(2-ethylhexyl)phthalate,alpha- terpen and alpha-pinene as important components. Comparison of chromatograms showed that di-limonene and bis(2-ethylhexyl)phthalate were exists as 2 common components in persuan maple and Caucasian maple tree. These compounds can very important in durability and consumption its.

Keywords

Main Subjects

Chemistry of wood

References

- Ashrafi, S., 2011. Identification and comparison of chemical components in wood and bark of planted elder pine and plane tree by GC-MS methods, graduated of master science, Islamic Azad University of Chalous Branch, 92-93 , (In Persian).

- Barzan A. and Soraki, S., 2002. Procedure of experimental for pulp and paper, Mazandaran Wood and Paper Industries, Sari, Iran, 111-121, (In Persian).

- Balaban, M., 2001. The extractives and its structural in wood and bark of oak. Holzforschung, 55(1), 478-486.

- Holmbom, B., 1977. Improve gas chromatographic analysis of fatty and resin acid mixtures with special reference to tall oil. JAM Oil Chemistry, 54(1), 284-243.

- Hossieni, S.V., 1991. Chromatography methods, Center of edition, Tehran, Pp:29-38, (in Persian)..

- Hosseini Hashemi, S.K., Parsapajouh, D., Khademi Eslam, H., Mirshokraie, S.A. and Hemmasi, A.H., 2007. Identification of extractives chemical components in Iranian walnut by GC/MS methods, Journal of Agriculture Science, Tehran, Iran, 12(4), 126-132, (In Persian).

- Khazraie, L., 2006. Separating and Identification of lipophilic compounds in wood and bark extractives in beech by GC-MS methods, Thesis of master science, Payame- noor Univ. Tehran, Pp:1.

- Mirshokraei, S.A., 2002. Wood chemistry. Aieg edition.Tehran, press. 194 p. (Translated in Persian)

- Meszaros, E., Jakab, E. and Varhegyi, G., 2006. TG/MS, Py-GC/MS and THM-GC/MS study of the composition and thermal behavior of extractive components of Robinia pseudoacacia, J. Anal. Appl. Pyrolysis 79: 61-70.

- Parsapajouh, D., 1993. Atlas of Iranian northern woods. Tehran Univ. Press, 48 and 106 p. (In Persion).

- Rahmani, H. and Abdolkhani, A., 2010. Characterization and removal of resins from mixed tropical hardwoods, Iranian Journal of Wood and Paper Industries, 1(1), 45-46, (In Persian).

- Technical Association of Pulp and Paper Industry (TAPPI), 2009. Standard Test Methods, Tappi Press, Atlanta, GA. USA.

- Torkman, J., 1992. Analyzing of bark extractives in fives species of Iranian hard woods trees, Thesis of master science, Tarbiat Modares Univ. Tehran, pp:1-2.

- Tunalier, Z.K., 2003. Wood essential oils of Junipers foetidissima willd, Forshung, 57(1), 140-144.

- Vaysi, R., 2010. Identification and comparison the extractives chemical components in natural and planted cypress tree by GC-MS methods, Journal of sciences and techniques in natural resources, Chalous, Iran, 4(1), 79-80. (In Persian).

- Vaysi, R., 2013. Identification and comparison of chemical components in sweet locust and false acacia wood extractions by GC-MS methods, Iranian J. of Wood and Paper Sci. and Technology 28(4), 755-762. (in Persian).

- Vaysi, R., 2011. Identification of the extractives chemical compounds in newsprints by GC-MS methods, Asian journal of chemistry,23(11),5155-5156.

- Xiao, B., Sun, X.F., and Sun, R.C., 2001. Extraction and characterization of lipophilic extractives from rice straw chemical composition, Journal of wood chemistry and technology, 21(1), 397-411.

Iranian Journal of Wood and Paper Science Research

A Study on the Possibility of Identification and Comparison of Metallic Ions and Chemical Components in Wood of Persuan maple and Caucasian maple tree by Atomic Absorption and GC-MS Methods

References

References

Volume 34, Issue 3 - Serial Number 69
November 2019
Pages 361-371

A Study on the Possibility of Identification and Comparison of Metallic Ions and Chemical Components in Wood of Persuan maple and Caucasian maple tree by Atomic Absorption and GC-MS Methods

References

References

Volume 34, Issue 3 - Serial Number 69November 2019Pages 361-371

Volume 34, Issue 3 - Serial Number 69
November 2019
Pages 361-371