Document Type : Research Paper
Authors
1 Assistant Prof., Wood and Forest Products Science Research Division, Research Institute of Forests and Rangelands, Agricultural Research Education and Extension Organization (AREEO), Tehran, Iran
2 Associate Prof., Wood and Forest Products Science Research Division, Research Institute of Forests and Rangelands, Agricultural Research Education and Extension Organization (AREEO), Tehran, Iran
Abstract
Background and Objectives: Wood fiber morphological characteristics are important factors influencing the suitability of wood as a raw material for pulp and paper production and vary along the radial direction of the stem. Understanding these variations and comparing fiber characteristics among different poplar clones can provide useful information for the preliminary assessment of plantation-grown wood. This study aimed to investigate radial variation in fiber dimensions and papermaking-related morphological indices in three clonal groups of black poplar (Populus nigra L.).
Materials and Methods: Three clonal groups of black poplar, P. nigra 62/154, P. nigra var. betulifolia, and P. nigra 42/51, established in a common plantation at the Alborz Research Station, Karaj, Iran, were investigated. Three trees were selected from each group, and one disc was collected at breast height from each tree. Two wood strips were obtained from each disc, and each strip was divided into three radial sections: near pith, middle, and near bark. Corresponding sections from the two strips at each position were combined, resulting in 27 composite samples. Following fiber isolation using the Franklin maceration method, fiber length, fiber diameter, lumen diameter, and cell wall thickness were measured, and papermaking-related morphological indices were calculated. Data were analyzed using mixed repeated-measures analysis of variance. Holm's method was used for pairwise comparisons, and the Benjamini–Hochberg procedure was applied to control for multiple testing.
Results: Radial position significantly affected all four primary fiber dimensions (q < 0.001). Mean fiber length at the near-pith, middle, and near-bark positions was 773.81, 971.80, and 1118.51 µm, respectively, with significant differences among all three positions. Fiber length increased from pith to bark in all nine sampled trees, with a mean difference of 344.70 µm between the near-pith and near-bark positions. Mean fiber diameter and cell wall thickness in the P. nigra var. betulifolia group were 29.08 and 5.72 µm, respectively, significantly higher than the corresponding values in group 62/154 (24.98 and 4.93 µm, respectively). No significant differences among clonal groups were observed in fiber length or lumen diameter. The slenderness ratio increased significantly from 32.34 near the pith to 40.55 near the bark (q < 0.001), whereas radial position and clonal group had no significant effects on the Runkel ratio or flexibility coefficient after adjustment for multiple testing. The interaction between clonal group and radial position was also not significant after adjustment.
Conclusion: Radial position significantly affected the main fiber dimensions of black poplar, with increasing fiber length and slenderness ratio from pith to bark representing the most prominent trends across all three clonal groups. Given the established use of poplar wood in the pulp and paper industries, these findings provide a better understanding of radial variation in fiber morphological characteristics and may contribute to the characterization and comparison of wood properties among the studied clones as raw materials for these industries. However, as direct pulping trials and evaluations of the resulting paper properties were not conducted in this study, definitive conclusions regarding the effects of the observed differences in fiber dimensions on pulping performance and paper quality cannot be drawn. Therefore, determining the actual suitability of the studied clonal groups for pulp and paper production requires direct pulping trials and evaluation of the resulting paper properties in future studies.
Keywords