Document Type : Research Paper

Authors

1 M.Sc. Building and Housing Research center (BHRC)

2 Expert of Engineering a-d Tecknology of sistan Balouchestan University

3 Ph.D., Wood and Paper Science Research Division, Research Institute of Forests and Rangelands , Iran,

Abstract

Cement board without fibres has low flexural strength and fails in small strain. To solve this problem and enhance other characteristics, the fibres are applied. Asbestos fibres which have individual properties have been used for reinforcing cement composites since the early 20th century. However in this decade, most countries have been banned the use of asbestos fibres in construction industries, because of its effect on human healthy. Natural fibres are one of the suitable alternatives for cement board production that have a good compatibility with cement matrix. In this research, to recognize the flexural behaviour which is the one of the most important characteristics for cement board, many laboratory samples have been made by three kinds of fibres and tested. These fibres obtained from agricultural wastes such as bagasse, wheat and eucalyptus. The scanning Electronic Microscopic studies were carried out to clarify the microstructures of composites. The results show that among the all types of fibres, bagasse has the most effect on increasing the flexural strength capacity for cement composite boards. 

Keywords

Main Subjects

-Bentur A., Midness S., Fiber Reinforced cementitious composites, Elsevier, 1990
-R.J. Leea and D.R. Van Orden '' Airborne asbestos in buildings'' Regulatory Toxicology and Pharmacology, Volume 50, Issue 2, March 2008, Pages 218-225
-Jeffrey J. Davisa, b and Brian L. Gulson '' Ceiling (attic) dust: A “museum” of contamination and potential hazard'' Environmental Research, Volume 99, Issue 2, October 2005, Pages 177-194 
-Coutts R. S. P., "A review of Australian research into natural fiber cement composites", Cem. Comcr. Comp, 27(2005) 518-526.
-Andonian, R., Mai, Y. W. & Cotterell, B., Strength and fracture properties of cellulose fiber reinforced cement composites. Int. J. Cem. Comp, 1(1979) 151-8.
-C. Asasutjarita, J. Hirunlab, J. Khedari, S. Charoenvai, B. Zeghmati and U. Cheul Shin'' Development of coconut coir-based lightweight cement board'', Construction and Building Materials, Volume 21, Issue 2, February 2007, Pages 277-288
-Carlos Negro, Luis M. Sánchez, Helena Fuente and Angeles Blanco '' Effects of flocculants and sizing agents on bending strength of fiber cement composites'', Cement and Concrete Research, Volume 35, Issue 11, November 2005, Pages 2104-2109
-Paki Turgut, '' Cement composites with limestone dust and different grades of wood sawdust '', Building and Environment, Volume 42, Issue 11, November 2007, Pages 3801-3807
-Luiz C. Roma Jr.a, Luciane S. Martelloa and Holmer Savastano Jr., '' Evaluation of mechanical, physical and thermal performance of cement-based tiles reinforced with vegetable fibers'', Construction and Building Materials, Volume 22, Issue 4, April 2008, Pages 668-674
-Holmer Savastano Jr.a, Vahan Agopyanb, , , Adriana M. Nolascoc and Lia Pimentel, '' Plant fibre reinforced cement components for roofing '', Construction and Building Materials, Volume 13, Issue 8, 1 December 1999, Pages 433-438
-Punyamurtula, Venkata K. ,'' Flexure Toughness of Polymer Fiber-reinforced Cementitious Materials.,'' International Journal of Damage Mechanics July 2008, Volume. 17 Issue 4, p363-371 
-Pehanich J. L.; Blankernhorn P. R. and Silsbee M. R., "Wood fiber surface treatment level effects on selected mechanical properties of wood fiber-cement composites", Cement and Concrete Research., Volume 34, 1 October 2004, Pages 59-65
-Kaufmann J.; Winnefeld F. and Hesselbarth D., "Effect of the addition of ultrafine cement and short fiber reinforcement on shrinkage, rheological and mechanical properties of Portland cement pastes", Cement and Concrete Composite Volume 26, Issue 8, December 2004, Pages 541-549
-Mohr B. J.; Nanko H. and Kurtis K. E., "Aligned Kraft pulp sheets for reinforcing mortar", Cement and Concrete Composite , Volume 27, Issue 3, September 2005, Pages  554-558